How to Maintain Your Fulmor Bottle

Proper maintenance keeps your Fulmor bottle producing high-concentration hydrogen for years. Here's a simple routine to follow.

Daily Care

1. Rinse the bottle with clean water after each use
2. Empty remaining water — don't leave standing water overnight
3. Leave the lid off to air dry

Weekly: Self-Clean Cycle

1. Fill with clean water to the max line
2. Press and hold the button for 5 seconds until the indicator flashes
3. The self-cleaning cycle runs for approximately 3 minutes
4. Discard the water after the cycle completes
5. Rinse once more with fresh water

The self-clean mode reverses the electrode polarity to dissolve mineral scale deposits that accumulate naturally from water use.

Monthly: Deep Clean

• Fill with a mixture of water and food-grade citric acid (1 teaspoon per 300ml)
• Let it soak for 15-20 minutes (do NOT run electrolysis during soak)
• Rinse thoroughly 3-4 times with clean water
• Run one self-clean cycle after rinsing

What to Avoid

• No hot water — never use water above 60°C / 140°F
• No carbonated water — damages the PEM membrane
• No juice, tea, or additives — only clean water
• No dishwasher — hand wash only
• No abrasive brushes — use a soft cloth for the exterior

Electrode Lifespan

With proper care, Fulmor's titanium-platinum electrodes are rated for 5000+ hours of operation. If you notice decreased bubble production or lower PPB readings after extended use, contact support@fulmor.com for guidance.